Hood Sensor Module - HP ProDesk 480 G4 MT Maintenance And Service Manual

Hood sensor module

Follow these steps to remove the hood sensor module:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Position the computer with the rear panel toward you.
4. Disconnect the hood sensor module cable (1) from the system board.
5. Release the hood sensor module (2) from the retention clip built into the computer chassis.
6. Remove the hood sensor module.
Reverse this procedure to install the hood sensor module.
26 Chapter 4 Removal and replacement procedures
Preparation for disassembly on page
Access panel on page 22).
21).