Display Assembly - HP Pavilion 14 Maintenance And Service Manual

Display assembly

This section describes removing the display assembly and disassembling display subcomponents. You must
remove the display from the computer to disassemble display subcomponents.
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the fan assembly (see
To remove the display assembly:
1. Peel the Mylar tape from atop the display connector (1), and then disconnect the display panel cable
from the system board (2).
2. Disconnect the small display panel cable from the system board (2).
3. Disconnect the wireless antennas from the WLAN module (3).
4. Remove the antenna cables from their routing path in the speaker (4).
5. Remove the four Phillips PM2.5×6.0 screws (1) and the two Phillips PM2.5×4.0 screws (2) that secure
the display assembly to the computer.
6. Lift the display to bend the hinges upward (3).
Bottom cover on page
Battery on page 29).
Fan on page 39).
27).
Component replacement procedures 43