Dell Edge 3001 Installation And Operation Manual page 58

• Disconnect
Enter the following at the command prompt to add a connection to the system.
For example:
Enter the following at the command prompt to provide the system what passkey is used on the access point.
For example:
Enter the following at the command prompt to provide the system what is the pass code for the access point.
For example:
Enter the following at the command prompt to bring up the connection (allows it to connect to the access point and get an IP
address).
For example:
B B luetooth
Run the following commands (For example, bluetooth keyboard):
1. Start the bluetoothctl console.
2. Turn on the device.
3. Register the agent for keyboard.
4. Put the controller in pairable mode.
5. Scan for nearby bluetooth device.
6. Stop scanning after the bluetooth keyboard is found.
7. Pair bluetooth devices.
8. Enter PIN code on the bluetooth keyboard, if required.
9. Trust the bluetooth keyboard.
10. Connect to the bluetooth keyboard.
11. Close the bluetoothctl console.
58