Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Husqvarna Manuals
  4. Power Tool
  5. LG 164
  6. Operator's manual

Husqvarna LG 164 Operator's Manual

Hide thumbs

Advertisement

Quick Links

LG 164, LG 204
EN
Operator's manual
2-31

Advertisement

loading

Related Manuals for Husqvarna LG 164

Summary of Contents for Husqvarna LG 164

  • Page 1 LG 164, LG 204 Operator's manual 2-31...

  • Page 2: Table Of Contents

    Contents Introduction..............2 Transportation, storage and disposal......22 Safety................7 Technical data.............. 26 Operation..............11 EC Declaration of Conformity........31 Maintenance..............16 Introduction California Proposition 65 WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
  • Page 3 Product overview (LG 164) To do a check of the vibration damping units on 1. Operator's manual page 9 . 2. Handle 3. Lock lever for the handle 6. Oil plug for the eccentric element 4. Type plate 7. Eccentric element 5.
  • Page 4 Product overview (LG 204) 1. Ignition key, only on Hatz engine with electrical start 7. Type plate 2. Handle 8. Eccentric element 3. Throttle control 9. Oil plug for the eccentric element 4. Hydraulic oil tank 10. Safety straps 5. Vibration damping units 11.
  • Page 5 Engine overview Honda Hatz 1. Muffler Read the manual carefully and make sure 2. Fuel tank that you understand the instructions before 3. Fuel tank cap you use the product. 4. Spark plug 5. Air filter Read the manual carefully and make sure 6.
  • Page 6 Move the product rear- ward. Manual start. Electrical start. Note: Other symbols/decals on the product refer to special certification requirements for some markets. Hydraulic oil level. Type plate The vibrations start. Symbol for a position of the throttle control. Risk of injury. Be careful around the drive belt.

  • Page 7: Safety

    Safety Safety definitions • Keep the product clean. Make sure that you can clearly read signs and decals. Warnings, cautions and notes are used to point out • Do not use the product if it is defective. specially important parts of the manual. •...
  • Page 8 Vibration safety • Cancer • Birth defects • Skin inflammation WARNING: Read the warning instructions • Use correct equipment to decrease the quantity of that follow before you use the product. dust and fumes in the air and to decrease dust on work equipment, surfaces, clothing and body parts.
  • Page 9 6 between the handle and the engine plate. WARNING: Read the warning instructions that follow before you use the product. Model LG 164: • Do not use a product with defective safety devices. • Do a check of the safety devices regularly. If the safety devices are defective, speak to your Husqvarna service agent.
  • Page 10 If the battery • Make sure that the vibration damping units are has a deformation or is damaged, speak to correctly installed. an approved Husqvarna service agent. • Examine the vibration damping units for damages and wear. •...

  • Page 11: Operation

    Safety instructions for operation near edges • Clean the product to remove dangerous material before you do the maintenance. • Disconnect the spark plug cap before you do the maintenance. WARNING: Read the warning instructions that follow before you use the product. •...
  • Page 12 To start the product (LG 164, Honda) 5. Pull the starter rope handle slowly until you feel resistance. 1. Open the fuel valve. 2. Set the throttle control to idle speed. 6. Release the starter rope handle to let the starter rope go back.
  • Page 13 To stop the product (Honda) is high, open the choke. 1. Set the throttle control to idle speed. 4. Set the engine ON/OFF switch to ON. a) LG 164: 5. Pull the starter rope handle slowly until you feel resistance. b) LG 204: 6.
  • Page 14 To start the product (LG 164, Hatz) 2. Pull the starter rope handle slowly until you feel resistance. 1. Set the throttle control to idle speed. 3. Release the starter rope handle to let the starter 2. Pull the starter rope handle slowly until you feel rope go back.
  • Page 15 3. Let the engine operate at idle speed for 2–3 minutes. 4. Set the throttle control to the stop position. This stops the engine if it has a manual start. a) (LG 164, Hatz): • To operate the product rearward, move the operation control fully rearward and release it.

  • Page 16: Maintenance

    Maintenance Introduction X = The instructions are given in this operator's manual. O = Refer to the instructions in the engine manual WARNING: Read and understand the safety supplied by the engine manufacturer. chapter before you do maintenance on the product.
  • Page 17 Engine maintenance, Honda Before use, After the Weekly, Yearly, each each 10 h first 20 h each 100 h 300 h Do a check of the drain valve for the air filter. Only appli- cable for engines that have a cyclone precleaner. Replace the engine oil.
  • Page 18 To clean the product To replace the engine oil (LG 164, Honda) CAUTION: Before you clean the product, attach a plastic bag tightly around the fuel If the engine is cold, start the engine for 1–2 minutes tank cap. This is to make sure that water before you drain the engine oil.
  • Page 19 This causes damage to the 11. Install the air filter in the opposite sequence. air filter and the risk increases that you To clean or replace the air filter (LG 164, Hatz) breathe the dangerous dust. WARNING: Do not clean the air filter with 1.
  • Page 20 Tighten the screw on the belt tensioner. 6. Install the V-belt cover. To replace the oil in the eccentric element 1. Remove the oil drain plug for the eccentric element and connect a hose. a) LG 164: 1114 - 002 - 03.04.2020...
  • Page 21 We recommend a 2-stage charger with constant voltage that automatically decreases to trickle charging when the battery is fully charged. Speak to your Husqvarna dealer for information about the correct battery charger. • Do a trickle charging 1-2 times during the winter season when the product is in storage.

  • Page 22: Transportation, Storage And Disposal

    Hydraulic system To replace the hydraulic oil To do a check of the hydraulic hoses WARNING: Risk of burn injury. The hydraulic oil becomes hot during operation • Examine the hydraulic hoses regularly. Replace of the product. Let the product become cool worn or damaged hydraulic hoses.
  • Page 23 Trolley overview 2. Attach the trolley strap to the product with the screw and washer. The trolley is an optional accessory. To install the trolley on the product 3. Put the hook of the trolley in the trolley strap. WARNING: Do not put your hand between the trolley and the bottom plate.
  • Page 24 7. Unlock the handle (A) and tilt the product rearward. 1. Lock the handle in upright position. 2. Attach the lifting equipment to the lifting eye. A label on the product identifies the correct position. 8. Move the product on the wheels. WARNING: Do not use metal hooks, chains or other lifting equipment with rough edges that can cause damage to...
  • Page 25 Obey the local recycling requirements and applicable regulations. • Do not discard the battery as domestic waste. • Send the battery to a Husqvarna service agent or discard it at a disposal location for used batteries. 1114 - 002 - 03.04.2020...

  • Page 26: Technical Data

    Technical data Technical data (LG 164) LG 164 Honda, manual start Hatz, manual start Net weight, kg/lb 350 mm: 147/324 350 mm: 165/364 450 mm: 156/344 450 mm: 168/370 600 mm: 184/406 Operation weight (EN500, incl. oil, ½ 350 mm: 148/326...
  • Page 27 Noise and vibration emissions, LG 164 Honda Hatz Sound power level, measured dB (A) Sound power level, guaranteed L dB (A) Sound pressure level at the operator's ear, L , dB (A) 350 mm: 81.9 350 mm: 84.1 450 mm: 82.4...
  • Page 28 LG 204 Honda, manual start Hatz, manual start Hatz, electric start Eccentric element, l/qts 0.5/0.53 0.5/0.53 0.5/0.53 SAE 10W-30, API Class SAE 10W-30, API Class SAE 10W-30, API Class Engine oil * Eccentric element oil SAE 10W-30, API Class SAE 10W-30, API Class SAE 10W-30, API Class Hydraulic oil Shell Tellus S3 V 32...
  • Page 29 Product dimensions (LG 164) Handle height, mm/in. Length including handle, 1069/42 1110/44 mm/in. Bottom plate contact area, 0.103/1.11 / Height, mm/in. 727/28.6 /sq. ft. 0.132/1.42 Length bottom plate, Width, mm/in. 350/13.8 or mm/in. 654/25.7 450/17.7 or 600/23.6 Length with handle folded, 748/29.4...
  • Page 30 Product dimensions (LG 204) Handle height, transport Length with handle folded, 1269/50.0 720/28.3 position, mm/in. mm/in. Handle height, operation Length including handle, 1126/44.3 1328/52.3 position, mm/in. mm/in. Bottom plate contact area, Height, mm/in. 0.1735/1.8675 754/29.7 /sq. ft. Length bottom plate, Width, mm/in.

  • Page 31: Ec Declaration Of Conformity

    EC Declaration of Conformity EC Declaration of Conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Reversible Plate Compaction Machine Brand Husqvarna Type/Model LG 164, LG 204 Identification Serial numbers dating from 2019 and onwards...
  • Page 32 www.husqvarnacp.com Original instructions 1140387-26 2020-04-06...

This manual is also suitable for:

Lg 204