Advertisement
12V(Power)
This amplifier should be wired directly to the vehicle battery using the appropriate size cable. Start
at the vehicle battery and run the power cable through to the amplifier. Avoid running the power cable
over engine components and near heater cores. The use of an in-line fuse or circuit breaker is a
must; this will prevent the risk of a potential fire caused by a short in your power cable Connect the
fuse holder or circuit breaker as close to the battery positive (+) terminal as possible (no farther then
18" from that battery). This fuse or circuit breaker should be no greater than the sum of the fuses found
on the chassis of your amplifier (also see specifications chart). You may now connect the cable to the
battery, but remember to leave the fuse out or circuit breaker "off" until all other cable connections
are made.
GND(Ground)
When grounding your amplifier, locate a metal area close to the amplifier that is good source of
ground (preferably the floor pan). Once again, investigate the area you wish to use for electrical
wires,vacuum lines, and brake or fuel lines. Use either a wire brush or sandpaper to eliminate
unwanted paint for better contact of the ground.
Now it's time to connect the power and ground cables to the amplifier. Cut both cables to length.
Use a Phillips screwdriver to loosen the BATT+ and the GND connections on the amplifier. Insert the
ground first, and then the +12V and please make sure that you place them into the correctly marked
terminals. Then tighten the screws down securely.
Advertisement
