WALL SLEEVE INSTALLATION INSTRUCTIONS FOR
THRU-THE WALL AIR CONDITIONERS
READ AND SAVE THESE INSTRUCTIONS
CAUTION
CAUTION
!
To avoid risk of personal injury, property damage, or
product damage due to the weight of this device and
sharp edges that may be exposed:
Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are
needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
Carefully inspect location where air conditioner will
be installed. Be sure it will support the weight of the
unit over an extended period of time.
Handle air conditioner with care. Wear protective
gloves whenever lifting or carrying the unit. AVOID
the sharp metal fins of front and rear coils.
Make sure air conditioner does not fall during
installation.
For New Construction install Frigidaire Wall Sleeve
(Part EA108T).
Remove old air conditioner and inspect sleeve for the
following:
Installation - Make sure
installed and in sound structural condition.
Dimensions-Measure the size to make sure the air
conditioner will fit.
Slope - There should
be
condensate to drain from the rear of the sleeve.
Check against Fig. A.
Wall Sleeve
REAR
Manufacturer-So the method of installation can be
determined.
If the installation and slope are suspect, then removal
and correct installation of a Frigidaire Wall Sleeve
(Part EA108T), is recommended.
FRIGIDAIRE
that sleeve is securely
a rearward
slope for
1/4" to 5/16"
FRONT
LEVEL
UNIT
Fig. A
Check the contents of the accessories supplied with
your air conditioner as shown below:
10
11
2
1
8
9
Number
Part name
1
Top/Bottom Trim Frame
Side Trim Frame
2
Plastic Mesh
3
Tapered Spacer Block Board
4
Tapered Spacer Block
5
Vertical Foam
6
Horizontal Foam
7
8
Vertical Trim Foam
9
Horizontal Trim Foam
10
Screw
11
Washer
3
4
5
7
6
QTY.
2
2
1
2
1
2
2
2
2
4
4
P/N: 819042236-01