Toro Workman GTX Operator's Manual page 27

Maintenance Service
Interval
Every 50 hours
Every 100 hours
Every 200 hours
Every 300 hours
Every 400 hours
Every 800 hours
Every 1,000 hours
Yearly
Note:
Download a free copy of the electrical schematic by visiting
machine from the Manuals link on the home page.
Important:
Refer to your engine owner's manual for additional maintenance procedures.
WARNING
Failure to properly maintain the machine could result in premature failure of machine systems
causing possible harm to you or bystanders.
Keep the machine well maintained and in good working order as indicated in these instructions.
CAUTION
Only qualified and authorized personnel should maintain, repair, adjust, or inspect the machine.
• Avoid fire hazards and have fire-protection equipment present in the work area. Do not use
an open flame to check fluid levels or leakage of fuel, battery electrolyte, or coolant.
• Do not use open pans of fuel or flammable cleaning fluids for cleaning parts.
Maintenance Procedure
• Remove the air-cleaner cover and clean out the debris. Do not remove the
air-cleaner element.
• Clean out the debris in the dust cap.
• Under special operating conditions (refer to Maintaining the Machine under Special
Operating Conditions)—replace the air-cleaner element. Replace the air-cleaner
element sooner if dirty or damaged.
• Under special operating conditions (refer to Maintaining the Machine under Special
Operating Conditions)—change the engine oil.
• Under normal operating conditions—replace the air-cleaner element. Replace the
air-cleaner element sooner if dirty or damaged.
• Under normal operating conditions—change the engine oil.
• Check the spark plug.
• Check the condition of the tires and rims.
• Torque the wheel-lug nuts.
• Inspect the steering and suspension for loose or damaged components.
• Check the front wheel camber and toe-in.
• Check the transaxle-fluid level.
• Check the operation of the neutral gear-shift position.
• Clean the engine-cooling areas.
• Inspect the brakes.
• Check the air filter for the carbon canister.
• Check the condition and tension of the drive belt.
• Check the tension of the starter-generator belt.
• Grease the front wheel bearings.
• Inspect the fuel lines and connections.
• Replace the fuel filter.
• Clean the primary drive clutch.
• Replace the service and parking-brake pads.
• Change the transaxle fluid.
• Change the brake fluid.
• Complete all of the yearly maintenance procedures that are specified in the engine
owner's manual.
www.Toro.com
27
and searching for your