Toro Workman GTX EFI Operator's Manual page 35
Hide thumbs
Also See for Workman GTX EFI:
- Operator's manual (60 pages) ,
- Operator's manual (60 pages) ,
- Operator's manual (60 pages)
Table of Contents
Advertisement
Installing the Hub and Rotor
1.
Apply a light coat of the specified grease to the
spindle
(Figure
36).
Figure 36
1. Nut retainer
2. Spindle nut
3. Tab washer
2.
Assemble the hub and rotor onto the spindle
with the rotor inboard
3.
Assemble the outboard bearing onto the spindle
and seat the bearing to the outboard race
(Figure
36).
4.
Assemble the tab washer onto the spindle
(Figure
36).
5.
Thread the spindle nut onto the spindle and
tighten the nut to 15 N∙m (11 ft-lb), while rotating
the hub to seat the bearing
6.
Loosen the spindle nut until the hub rotates
freely.
7.
Torque the spindle nut to 170 to 225 N∙cm (15
to 20 in-lb).
8.
Install the retainer over the nut and check the
alignment of the slot in the retainer and the hole
in the spindle for the cotter pin
Note:
If the slot in the retainer and the hole in
the spindle are not aligned, tighten the spindle
nut to align the slot and hole to a maximum
torque of 226 N∙cm (20 in-lb) on the nut.
g192344
4. Outer bearing
5. Hub, rotor, inner bearing,
race, and seal
6. Spindle
(Figure
36).
(Figure
36).
(Figure
37).
1. Cotter pin
2. Nut retainer
9.
Install the cotter pin and bend each legs around
the retainer
(Figure
10.
Install the dust cap onto the hub
11.
Repeat steps
at the other side of the machine.
Installing the Brakes and Wheels
1.
Clean the 2 flange-head bolts (3/8 x 3/4 inch)
and apply a coat of anti-seize compound to the
threads of the bolts.
2.
Align the brake pads to either side of the rotor
(Figure
32) and the holes in the caliper bracket
with the holes in the brake mount of the spindle
frame
(Figure
3.
Assemble the caliper bracket to the spindle
frame
(Figure
(3/8 x 3/4 inch), and torque the bolts to 47 to 54
N∙m (35 to 40 ft-lb).
4.
Align the holes in the wheel to the studs of the
hub and assemble the wheel to the hub with the
valve stem outward
Note:
Ensure that the mounting surface of the
wheel is flush with the hub.
5.
Secure the wheel to the hub with the lug nuts
(Figure
31), and torque the nuts to 108 to 122
N∙m (80 to 90 ft-lb).
6.
Repeat steps
wheel at the other side of the machine.
35
Figure 37
3. Dust cap
37).
(Figure
1
through
10
for the hub and rotor
36).
32) with the 2 flange-head bolts
(Figure
31).
1
through
5
for the brake and
g192345
37).
Advertisement
Table of Contents
