Sealey LED360.V3 Series Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instructions
1. safety
1.1. electrical safety for use of charger.
warning! do not use any other type of charger with this product, other than the supplied mains or car charger. failure to observe
‰
this warning could result in injury and or fire and will invalidate the warranty.
warning! it is the user's responsibility to read, understand and comply with the following electrical instructions:
‰
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.
An rccB (residual current circuit Breaker) should be incorporated in the main distribution board. We also recommend that an rcd
(residual current device) is used with all electrical products, particularly portable equipment which is plugged into an electrical
supply not protected by an rccB.
You must also read and understand the following instructions concerning electrical safety.
9
The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable Appliance tester (PAt), at least once a year.
the Health & safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
You must ensure that you inspect the charger plug, cable and connector for wear and damage to ensure items are safe before
9
connecting to the mains power supply. if worn or damaged do not use.
check that the voltage marked on the charger plug is the same as the lamp.
9
uncoil the cable between charger and the lamp.
9
ensure the lamp is fully charged before initial use.
9
do not pull the charger plug from the mains socket by the lead.
8
do not try to take the charger plug apart.
8
do not use the charger plug to charge or power any other electrical item.
8
do not get the charger wet, or use in wet, damp conditions (for indoor use only).
8
do not turn the lamp on when it is being charged.
8
do not shine directly into your, another person's or an animal's eyes.
8
do not allow children to use the lamp.
8
do not handle or move the lamp whilst it is being charged.
8
do not use the lamp if you suspect that the battery or the lamp casing is damaged.
8
do not leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
8
recharge the battery at least once every six months of non-use.
do not try to take the charger plug apart.
8
do not use the charger plug to charge or power any other electrical item.
8
do not get the charger wet, or use in wet, damp conditions (for indoor use only).
8
do not attempt to open, disassemble, modify or service the battery pack.
8
do not crush, puncture, short external contacts or dispose of in fire or water.
8
do not expose to temperatures above 60°c (140°).
8
replace only with the battery pack designated for this product.
recycle or dispose of used battery as stipulated by local regulation.
if the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. if it gets in your eyes, rinse thoroughly with cool
water and seek immediate medical attention
2. introductions
unique and innovative 360° swivel and tilt function enables light source to be positioned in any direction. exclusive patented design owned and
registered to sealey. each lamp houses 10 super bright smd leds providing up to 400 lumen output with 120° spread of light, illuminating the
whole work area. includes an additional high power 3W led in the end for use as a directional torch. features two swivel hooks and three rubber
covered magnets, two on the rear and one on the end, which allow hands free operation. High quality 2.2Ah lithium-ion battery for longer life, no
memory effect and a much slower discharge than traditional ni-mH batteries. micro usB charging port. supplied with mains and in car charger.
© Jack sealey limited
instructions for
rechargeable 360° inspection lamp
10 smd led+3w led lithium-ion
led360.V3 series
model no:
introduction
Original Language Version led360.V3 | issue 1 25/07/16