Bosch Rexroth RE 07009-MON General Assembly Instructions page 11

RE 07009-MON/11.17 | Assembly Instructions for Hydraulic Power Units
WARNING!
5.1.5 Transport using forklifts and similar floor conveyors
Danger to life due to falling or uncontrolled movement of the hydraulic
power unit!
If not transported appropriately, the hydraulic power unit may be knocked, fall or
move in an uncontrolled way.
When using floor conveyors as a means of transport, ensure a stable center of
f
gravity position.
The hydraulic power unit must not deviate from its intended orientation.
f
Secure the hydraulic power unit against any resulting acceleration forces as
f
required.
When using floor conveyors, the hydraulic power unit may only be transported
by personnel who can prove they hold the relevant qualifications, including
safety training, for the respective device.
You should proceed as follows:
Using suitable temporary protective devices e.g. wooden or plastic elements,
f
protect the hydraulic power unit against the contact surface of the fork, so that
the paintwork cannot be damaged during lifting and transport.
Secure the hydraulic power unit at the forklift against tilting. To this purpose,
f
fuse suitable attachment devices like e.g. tie downs.
Carefully lift the hydraulic power unit, taking into consideration the stable
f
center of gravity location and transport it to the desired position.
Ensure that the built-on components of the hydraulic power unit do not come
f
into contact with the attachment device or lifting tools during transport
(see Fig. 4).
Carefully set the hydraulic power unit down again and remove the holding
f
down / lifting equipment and any temporary protective devices.
Fig. 4: Transport using forklifts
Bosch Rexroth AG 11/20