Care And Maintenance; Optional Accessories; Troubleshooting - DeWalt DXF2042 Instruction Manual

5. Fan Connection: Plug fan directly into
120 volt A.C., 60Hz wall outlet. Be sure plug
ts tightly in outlet. A loose connection may
cause overheating and damage to the plug
or fan.
NOTE: To prevent overloading a circuit, do
not plug the fan into a circuit that is servicing
other electrical loads.
6. Turning Fan On: Place fan on stable
level surface. Plug fan into properly grounded
outlet. To start the fan, turn the switch from
the OFF position to the desired fan speed.
7. Turning Fan Off: To turn the fan off, turn
the switch from the current fan speed setting
to the off position. Remove plug from outlet.
8. Adjusting Fan Tilt: Loosen the
adjustment knob until the drum rotates freely
on the frame. Adjust the fan to desired tilt
angle and re-tighten the knob. Do not
overtighten adjustment knob.

CARE and MAINTENANCE

Cleaning:
WARNING: Before cleaning the fan be sure
to disconnect power cord from the plug.
Clean the grille surface with a clean damp cloth.
Do not use harsh chemical or abrasive cleaners.
WARNING:
DO NOT IMMERSE THE FAN
OR ANY WIRES IN WATER. Replace front grille
before fan use and allow fan to dry completely
before use. Periodic grille cleaning with a
vacuum will prevent dust build up. The motor
is sealed and does not require any interior
maintenance, cleaning or lubrication.
Maintenance: The Internal motor bearings
are permanently lubricated at the factory and
do not require any additional lubrication.
Repair:
WARNING: DO NOT OPERATE THE FAN
WITHOUT THE GRILLE IN PLACE. DO NOT
USE THE FAN IF IT HAS MALFUNCTIONED
OR BECOME DAMAGED IN ANY WAY.
Storage: Keep original carton for storage
of the fan. Coil and tie the power cord to avoid
damage during storage.
Free warning label replacement: If
warning labels become illegible or are missing,
please call 1-888-899-0146 for free
replacement.

OPTIONAL ACCESSORIES

WARNING: Since accessories, other than
those offered by D WALT, have not been
E
tested with this product, use of such
accessories with this appliance could be
hazardous. To reduce the risk of injury, only
D WALT recommended accessories should be
E
used with this product.

TROUBLESHOOTING

WARNING:
TO REDUCE THE RISK OF INJURY
FROM MOVING PARTS AND/OR
ELECTRICAL SHOCK, TURN POWER
SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL
OUTLET BEFORE PERFORMING
TROUBLESHOOTING CHECKS.
Minor problems often can be xed without
calling customer service.
PROBLEM CAUSE
Unit will not 1. No power to unit.
2. Switch not on.
run.
Unit is not 1. Obstructions are
rotating. keeping the fan
from working.
Unit runs but 1. Unit has been
the fan severely jolted
makes loud causing fan blade
scraping
to rub against
noise. housing or
housing to deform.
Unit runs but 1. Dirt build up on
vibrates fan blade.
excessively. 2. Severe jolt has
bent motor shaft.
WARNING:
If the supply cord is damaged, it
must be replaced by the manufacturer, its service
agent or similarly quali ed persons in order to
avoid a hazard.
TOOL GUARANTEE
5
ENGLISH
SOLUTION
1. Plug unit in.
2. Place in "ON"
position.
1. Check for
obstructions. If you
nd an obstruction,
turn the fan off. Unplug
the fan and carefully
remove the obstruction.
Plug the fan in and turn
it on again by referring
to the operating
instructions.
1. Contact customer
service.
1. Contact customer
service.
YEAR
LIMITED
GUARANTEE
5