Frigidaire FEB798WCCI Installation Instructions Manual

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
Your new wall oven has been designed to fit a limited variety of cutout sizes to make the job of installing
easier. The first step of your installation should be to measure your current cutout dimensions and
compare them to the cutout dimensions chart below or next page for your model. You may find little or
no cabinet work will be necessary.
Do not remove spacers (if equipped) on the side walls
and/or on the back of the built-in oven. These spacers center the
oven in the space provided. The oven must be centered to prevent
excess heat buildup that may result in heat damage or fire.
DO NOT INSTALL THESE WALL OVENS IN A BASE CABINET
WITH A COUNTERTOP ABOVE IT (Models 24" and 27" only).
NOTE: Base must be capable of supporting 150
pounds (68 kg).
** NOTE: Allow at least 19 3 /8" (49.2 cm)
clearance for door depth when it is open.
NOTE: Dimension G is critical to the proper
installation of the built-in oven. If the oven
decorative trim (ventilation) does not but against
the cabinet, or if noise is heard on convection
models, verify dimension G to assure it is
according to the required dimension.
NOTE: For a cutout height greater than H Min.
dimension add one 2" (5 cm) wide wood shim
to each side of the opening under the appliance
side rails.
MODEL
24" (61 cm) Wall Oven
27" (68.6 cm) Wall Oven
30" (76.2 cm) Wall Oven
MODEL
24" (61 cm) Wall Oven
27" (68.6 cm) Wall Oven 24 7/8 (63.2)
30" (76.2 cm) Wall Oven 28 1/2 (72.4)
All dimensions are in inches (cm).
Some models are not available in Canada.
Recycled paper
**Door Open
(see note)
24", 27" AND 30" SINGLE OVENS
(Double Ovens see Figure 2)
PRODUCT DIMENSIONS
A
23 7/8 (60.6)
26 7/8 (68.2)
29 7/8 (75.9)
CUTOUT DIMENSIONS AND CABINET WIDTH
Min. F Max.
22 (55.9) 22 1/4 (56.5)
25 1/4 (64.1)
29 (73.7)
Printed in Canada
1
(3.8 cm)
Min.
C
3
28 /
32
B
(71.4 cm)
r
Space
(78.7 cm)
D
2" (5.1 cm) Wide Wood
A
* Suggested distance from floor is 31" (78.7 cm).
Minimum required distance is 18" (45.7 cm).
Except for 30" models, minimum required distance
is 4 1/2" (11.4 cm).
Figure 1
B C (wrapper)
30 3/4 (78.1) 21 11/16 (55.1)
30 3/4 (78.1) 24 11/16 (62.7)
29 7/8 (75.9) 28 3/8 (72.1)
G (Min.) Min.
23 1/2 (59.7) 28 1/8 (71.4)
23 1/2 (59.7) 28 1/8 (71.4)
24 (61) 28 1/4 (71.8)
1
I
1
/ "
2
G
H
F
"
31"*
2" (5.1 cm)
Min.
Spacer if Needed
25 3/8 (64.5)
25 3/8 (64.5)
25 3/8 (64.5)
H Max.
30 1/8 (76.5) 24 (61) Min.
30 1/8 (76.5) 27 (68.6) Min.
28 7/8 (73.3) 30 (76.2) Min.
P/N 318201506 (0002) Rev. A
English – pages 1-8
Español – páginas 9-16
Français – pages 17-24
Hole for
Cable
Electrical
Junction Box
3" (7.6 cm)
Max.
D
I