Surface-Mounted Installation - Miele KM 6520 FR Operating And Installation Instructions

Surface-mounted installation

Preparing the worktop
 Create the worktop cut-out.
Remember to maintain the minimum
safety distances (see "Installation –
Safety distances").
 Seal any cut surfaces on wooden
worktops with a special varnish,
silicone sealant or resin to prevent the
wood from swelling as a result of
moisture ingress. The sealant must
be heat-resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
The seal under the appliance ensures
that the hob will sit securely in the cut-
out without slipping. Any gap between
the appliance frame and worktop will
become smaller over time.
Securing the spring clamps – wooden
worktops
The exact positioning of the spring
clamps is shown in the individual hob
diagrams.
 Position the spring clamps  on the
top edge of the cut-out in the
positions shown in the hob
illustration.
 Fasten the spring clamps  using the
3.5 x 25 mm wood screws supplied
with the appliance.
Installation
65