Adjusting The Depth Of Cut - Toro Flex-Force Power System 51833 Operator's Manual

Adjusting the Depth of Cut

1. Remove the battery from the edger.
2. Loosen the wing nut on the wheel and move it
up or down in the track to increase or decrease
the depth (Figure
Figure 10
3. Adjust the depth so that the blade barely touches
the ground when the machine is held in a normal
working position.
4. Tighten the wing nut.
5. Standing in a normal working position, check the
depth of cut again and correct if necessary.
10).
g333293
12