Pioneer XVDV360 Setting Up

Setting up your DVD/CD Receiver
When connecting this system or changing connections, be sure to switch the power off with the STANDBY/ON button, and disconnect the power cord from the AC outlet.
Do not use these speakers with any other system or amplifier as this may result in damage or fire.
1 Check that you have all the accessories, then put
the batteries in the remote control.
Power cord
Remote control
STANDBY TUNER
/ON DVD/CD (FM/AM)
Video cord OPEN/
CLOSE
USB LINE
AUDIO
1 2 3
SUBTITLE
4 5 6
ANGLE
7 8 9
ZOOM
CLEAR DISPLAY
0
FM antenna
TOP MENU TUNE MENU
AA size IEC R6
ST ENTER ST
HOME
MENU dry cell batteries
RETURN
TUNE
SETUP TEST TONE SURROUND SOUND (to confirm
system operation)
TV CONTROL SLEEP
INPUT CHANNEL VOLUME
MUTE VOLUME
AM loop antenna
3
1 2
3
Connect each speaker using the color-coded speaker cords.
Match them to the colored speaker terminals on the rear
panel of the DVD/CD receiver.
C /
R
P
COMPONENT R
FRONT R
VIDEO LINE
C /
B
DEO L
P
B
DEO Y R
SURROUND
VIDEO OUT AUDIO IN
For the best surround sound, setup your speakers
as above. The front left and right speakers should
be about 6 ft to 9 ft apart.
These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of
electric shock when connecting or disconnecting the speaker cables, disconnect
the power cord before touching any uninsulated parts.
Speaker Setup Guide
Check that you have all the speaker accessories.
• Front speakers x 2 • Center speaker x 1
• Speaker cords x 6
Front left (White) Surround left (Blue)
Standard surround 5-spot setup
This is a standard multichannel
surround sound speaker setup for
optimal 5.1 channel home theater
sound.
Surround
left
1 Attach the smaller non-skid pads to the base of each of the front,
surround and center speakers. The four large non-skid pads are
for the subwoofer (as shown).
Use the supplied adhesive to attach 4 pads to the base (flat surface) of each speaker.
Center speaker
Front and surround speakers
2
Connect the speaker system.
Refer to the Setting up your DVD/CD Receiver (the other part of this setup guide) to
connect the speakers properly. Place them as shown in the diagram above for optimal
surround sound.
3 Make sure the Front Surround mode is switched off.
See the operating instructions for more on using Front Surround.
2 Connect the AM and FM antennas to the rear panel of the DVD/CD receiver.
1 Pull off the protective
shields of both AM antenna
wires.
Push open the tabs, then insert
2
one wire fully into each terminal.
3
Release the tabs to secure the AM
antenna wires.
Fix the AM loop antenna to the
4
attached stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow (fig. A) then
clip the loop onto the stand (fig. B).
Note: If you plan to mount the AM antenna
to a wall or other surface, secure the stand
with screws (fig. C) before clipping the loop
to the stand. Make sure the reception is clear.
5 Place the AM antenna on a flat
surface and point in the direction
giving the best reception.
Don't let it come into contact with metal
objects and avoid placing near computers,
television sets or other electrical appliances.
Surround right
(Grey)
L CENTER Listening position
SUB
R L
WOOFER
SPEAKERS
Center (Green)
• Subwoofer x 1
• Surround speakers x 2
Front right (Red) Surround right (Grey)
Wall mounting the speakers
All the speakers (except the subwoofer, which should be placed
on the ground) have mounting holes, and depending on the
speaker setup you choose, you can wall-mount the front, center
Subwoofer
and (5-spot setup only) surround speakers.
Front left Front right
Center
Surround
right
Listening position
0.2 in. to 0.28 in.
Before mounting (see above), keep in mind the following points:
• Remember that the speaker system is heavy and that its
weight could cause the screws to work loose, or the wall
material to fail to support it, resulting in the speaker falling.
Make sure that the wall you intend to mount the speakers on is
strong enough to support them. Do not mount on plywood or
soft surface walls.
• Mounting screws are not supplied. Use screws suitable for the
Subwoofer
wall material and support the weight of the speaker.
• If you are unsure of the qualities and strength of the walls,
consult a professional for advice.
• Pioneer is not responsible for any accidents or damage that
result from improper installation.
fig. A
4
fig. B
ANTENNA
fig. C
FM
AM LOOP UNBAL 75Ω
6 Connect the FM wire antenna to the FM UNBAL 75 Ω antenna terminal.
For best results, extend the FM antenna fully and fix to a wall or door
frame. Don't drape loosely or leave coiled up.
The signal earth (H) is designed to reduce noise that occurs when an
Note:
antenna is connected. It is not an electrical safety earth.
Connect each speaker as shown below.
Surround left
(Blue)
Color-coded connector
(Connect to rear panel)
1 Twist and pull off the protective
shields on each wire.
2 Connect the wires to the
speaker. Match the colored
wire with the color-coded
label (above the tabs), then
insert the colored wire into
Subwoofer (Purple)
the red (+) tab and the other
wire with the black (–) tab.
Connect the other end to the
3
color-coded speaker terminals
on the rear of the DVD/CD
receiver (as shown at left).
Make sure to insert completely.
Upper three terminals
The small lug at the wire-end of
Front left
the speaker plug should face up
(White)
or down depending on whether
it's being plugged into one of
the upper or lower three
speaker terminals. Please make
Lower three terminals sure to connect correctly.
• Speaker stands x 2
• Non-skid pads
(large) x 4
• Non-skid pads
(small) x 20
• Screws x 2
Center (Green) Subwoofer (Purple)
0.2 in.
0.4 in.
Caution
Using the remote control
The remote control can be used within a range of about
23 feet from the remote sensor on the front panel, and
within a 30 degree angle.
Precautions:
• The remote control may not work if there is an obstacle
between the remote control and the display unit, or if the
remote control is not directed towards the remote sensor
of the display unit at the correct angle.
• The remote control may not work properly if strong
light such as direct sunlight or fluorescent light is shining
onto the unit's remote sensor.
• The remote control may not work properly when this
unit is used near devices emitting infrared rays, or when
remote controls of other devices which use infrared rays
6
are used. Also, the use of this remote control may cause
other devices to work improperly.
• When the operating range of the remote becomes too
short, replace the batteries.
Remote control battery caution
Incorrect use of batteries may cause leakage or
rupture.
Always be sure to follow these guidelines:
• Always insert batteries into the battery compartment
correctly matching the positive ª and negative ·
3
1
polarities, as shown by the display inside the
compartment.
• Never mix new and used batteries.
2
• Batteries of the same size may have different voltages,
depending on brand. Do not mix different brands of
batteries.
• When disposing of used batteries, please comply with
governmental regulations or environmental public
instruction's rules that apply in your country or area.
• In order to prevent battery leakage, remove the
batteries when not using the remote control for an
extended period (one month or more). If leakage occurs,
carefully wipe away any battery fluid inside the
compartment, and replace the batteries with new ones.
• Do not allow books or other objects to rest on top of
the remote control, since the buttons may be depressed,
causing faster exhaustion of the batteries.
• Do not use or store batteries in direct sunlight or
excessively hot places, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or catch
fire. It can also reduce the life or performance of batteries.
Color-coded wire
4 Connect the DVD/CD receiver to your TV, then connect the
(Connect to speaker)
supplied power cord.
Connect one end to a video input on your TV.
1
Use the supplied video cord.
2 Connect the other end to the video output of the DVD/CD receiver.
This player is equipped with copy protection technology. Do not connect this
player to your TV via a VCR using AV cables, as the picture from this player will not
appear properly on your TV.
3
Connect the power cord to the AC inlet.
ANTENNA C /
R
P R
COMPONENT
VIDEO
C / B
VIDEO
P B
FM
AM LOOP UNBAL 75 Ω
S-VIDEO Y
HDMI OUT VIDEO OUT
HDMI OUT
Congratulations! You're done setting up.
Printed in
Front surround
3-spot setup
This setup is ideal when rear surround
speaker placement isn't possible or
you want to avoid running long
speaker cables in your listening area.
1 Attach the smaller
non-skid pads to the
base of the front
and center speakers
and to the speaker
stands. The four
Front speakers
large non-skid pads
are for the
subwoofer.
Use the supplied adhesive
to attach 4 pads to the
base (flat surface) of each
speaker or stand.
2
Attach the surround speakers to
the speaker stands.
For each speaker, line up the spurs on the
stand with the holes on the back of the
speaker and insert, then secure the speaker
to the stand with the screw provided.
3 Connect the speaker system.
Refer to the Setting up your DVD/CD Receiver (the other part of this setup guide) to
connect the speakers properly. Place them as shown in the diagram above for optimal
surround sound.
4 Turn the speakers as shown, following the guide marks for optimal
Front Surround.
Turn each surround speaker so that the guide markers on the stand base are lined up
horizontally in the direction the listening position (see below). This is only necessary
when you are using the Front Surround mode (MODE ON). See the operating
instructions for more on using Front Surround.
Additional notes on connecting antennas
• Keep antenna cables away from the main unit and other cables.
• To assure optimum reception, pull the FM antenna so that it is
fully extended and not coiled or hanging at the rear of the unit.
• If reception with the supplied antenna is poor, see the Other
connections section in the main operating instructions for details
on connecting outdoor antennas.
Additional notes on speaker placement
If your listening room is of adequate size, place the speakers as
shown in step 3 to achieve the optimum surround sound effect. If
you are listening in a fairly small room and a typical surround
speaker setup is not possible, see Home theater sound setup in the
instruction manual and the Speaker Setup Guide for information on
the Front Surround 3-spot setup option.
When using the standard surround speaker setup as shown in
step 3, please observe the following guidelines:
• Install the main front left and right speakers at an equal
distance from the TV.
• For optimum effect, place the rear speakers slightly above ear
level.
• Install the center speaker above or below the TV so that the
sound of the center channel is localized at the TV screen.
Precautions:
• When installing the center speaker on top of the TV, be sure to
secure it with tape or some other suitable means. Otherwise, the
speaker may fall from the TV due to external shocks such as
earthquakes, endangering those nearby or damaging the speaker.
• Do not connect the supplied speakers with any other amplifier.
This may result in malfunction or fire.
• Make sure that all the bare speaker wire is twisted together
and inserted fully into the speaker terminal. If any of the bare
speaker wire touches the back panel it may cause the power to
cut off as a safety measure.
• The front, center and surround speakers supplied with this
system are magnetically shielded. However, depending on the
installation location, color distortion may occur if the speaker is
installed extremely close to the screen of a television set. If this
happens case, turn the power switch of the television set OFF, and
turn it ON after 15 min to 30 min. If the problem persists, place
the speaker system away from the television set.
• The subwoofer is not magnetically shielded and so should not
be placed near a TV or monitor. Magnetic storage media (such as
floppy discs and tape or video cassettes) should also not be kept
close to the subwoofer.
• Do not attach the subwoofer to the wall or ceiling. They may
fall off and cause injury.
VIDEO IN
VIDEO
LINE FRONT R L CENTER
L
R
AC IN
R L SUB
SURROUND WOOFER
AUDIO IN
SPEAKERS
AC IN
To AC outlet
Imprimé au <ARE7604-A>
Surround Subwoofer Surround
left right
Center
Front left Front right
Listening position
Center speaker
Subwoofer Speaker stand
Caution
• Please don't attach the
surround speakers to the wall for
the Front surround 3-spot setup.