Table of Contents
Advertisement
Entering Alarm
Parameters
Programming Site Data
The Alarms option enables you to enter parameters necessary to set
up alarms. To enter the option, scroll to the Alarms entry on the
Program / IO Menu and press
Note: Input/Output Menu options may appear in a different order,
depending on where each option card is installed. Cards are
numbered from right to left.
The screen appears similar to Figure 1-25 below. To step through
each parameter, press the [ ] key. Refer to the Program Menu Map,
Figure 1-36 on page 1-39.
Function
Trigger Point
Figure 1-25: Alarm Setup Window
1. The first prompt enables you to select the function from four
Disabled, High, Low,
choices:
a. Press
[ENTER]
to open the drop-down menu.
b. Scroll to the desired function.
c. Press
[ENTER]
to confirm your selection.
[ENTER]
.
Alarm Setup
Low
Velocity
m/s
Failsafe
2500
Cancel
OK
All Faults.
and
February 2009
1-25
Advertisement
Table of Contents
