Monitor; Beginning/ End Of Transmission Signal - Kenwood TK-278G Instruction Manual

Monitor

Your dealer can program a key with the Monitor
function one of four ways:
A Press and hold the Monitor key to hear background
noise. Release the key to return to normal operation.
B Momentarily press the Monitor key to hear
background noise. Press the key again to return to
normal operation.
C Press and hold the Monitor key to deactivate QT,
DQT, or 2-Tone signalling. Release the key to return to
normal operation.
D Momentarily press the Monitor key to deactivate QT,
DQT, or 2-Tone signalling. Press the key again to
return to normal operation.
You can use the Monitor key to listen to weak
signals that you cannot hear during normal operation
and to adjust the volume when no signals are
present on your selected channel.

Beginning/ End of Transmission Signal

Your dealer can enable or disable the Beginning/
End of Transmission identification signals. These
signals are used to access and release some
repeaters and telephone systems.
To send a Beginning of Transmission signal, either
press the PTT switch, or press the
To send an End of Transmission signal, either
release the PTT switch or press the
by the # key.
• Ask your dealer which method has been activated on
your transceiver.
key two times.
key followed
29