2.6
RAM and 2.5" Storage Drive installation
Before starting RAM and Storage Drive installation, be sure the system is powered
down (not in sleep mode) and the power has been disconnected. Also, make sure the
components are ready for installation. It is best to perform installation on a flat surface,
with the system removed from its mounting. For specifications and requirement of
memory and storage devices, see Chapter 1: Specifications.
Step 1: Separate the system from the panel by removing the screws securing the two
together.
Step 2: Remove the Storage Drive if one has been previously installed or mounting
bracket if not. Then, remove the blower assembly.
Step 3: Insert the RAM modules one at a time, at a roughly 30° angle, then gently push
down until the secured. Mind the order memory is installed when using two modules.
Step 4: Reinstall the blower assembly.
Chapter 2 – Hardware Information
32