Black & Decker BCW27MW Instruction Manual page 30

ENGLISH
INSTALLATION INSTRUCTIONS
Leveling the Washer Dryer Combo
When moving the unit to the final location make sure the leveling legs are positioned
close to the washer and not extended to avoid damage to the leveling legs.
The leveling legs can be adjusted by turning them to raise or lower the leg with an
adjustable wrench (not included).
After positioning the unit at its final location, it should not rock when pressing down
on the top corners of the unit. A leveler can also be used. If the unit is not stable, the
leveling legs should be adjusted to stabilize.
All 4 leveling legs should be pressed firmly into the ground, and the unit should be
completely stable before operating the washer.
Connecting the Inlet Hoses
Connect (blue) inlet hose to the cold water supply. Turn clockwise to tighten.
Connect the other end of hose inlet of the cold water supply to the (blue) inlet valve
on the back of the unit marked C by turning clockwise to tighten.
Connect the (red) inlet hose to the hot water supply. Turn clockwise to tighten.
Connect the other end of hose inlet of the hot water supply to the (red) inlet valve on
the back of the unit marked H by turning clockwise to tighten.
Turn on the water supply to make sure there is no leak in the connections. If any
leakage occurs, tighten the connection by turning clockwise.
Page 30