Toshiba DW-08T1(S)-MY Instruction Manual page 32

Problem
Noise from
dishwasher
Beats in water
pipe
Dishes remain
dirty after
washing
Glassware is not
glossy
White point on
dishes or
glassware
Black or grey
imprints on dishes
Dishwashing
powder remains in
adding position
Dishes are not
completely dry
32
Possible cause
Dishes are loose.
This may be caused by site
installation or cross section
Dishes are not placed
correctly.
The program is not
powerful enough.
Dishwashing powder is
not enough.
the rotation of spray arm.
Filter assembly is dirty or
not properly installed on the
base, which may impede
the rotation of spray arm.
Add too much dishwashing
powder under soft water
conditions.
Hard water produces more
scale.
Friction between aluminum
utensil and dishes.
Placement of dishes
hinders the addition of
dishwashing powder.
Placement is improper.
Dishes are taken out too
early.
Program is wrong.
The dishes have poor
drainage ability.
Solutions
Suspend the program and reposition the
dishes.
In case of any doubts, please contact
Please see "Loading the basket"
information for details (Page 22).
Select a more powerful program.
Use more dishwashing powder or replace
new detergent.
Reposition the dishes so that spray arm
can rotate freely.
spray arm.
If soft water is used, use less powder and
select a shorter washing program to clean
the glassware.
Add dishwashing powder.
Use mild detergent to eliminate these
imprints.
Place the dishes correctly.
Please see " Loading the basket
information for details (Page 22).
Do not take dishes out immediately after
the program ends. Slightly open the door
let the vapor out and wait until dishes are
cool.
When shorter washing procedures are
used, washing temperature is lower and
program shall be selected.
These dishes have poor drainage ability,
which are not suitable to be washed in
dishwasher.
"