Alarm Operation; Sleep Timer Operation - JVC RA-E111B Instruction Manual

ALARM OPERATION

NOTE: Before setting the alarm time, make sure the Clock has been set.
Setting Alarm 1 or Alarm 2
• In standby mode, press and hold AL1 or AL2 for 2 seconds. The hour and minute
digits will flash.
• Set the alarm time by repeatedly pressing HR and MIN respectively.
NOTE: Press and hold HR and MIN for fast forward.
• Press AL1 or AL2 again to select the alarm sound (OFF>BUZZER>RADIO in cycle).
Checking alarm time
Press and hold AL1 or AL2 for 2 seconds, the alarm time will flash on the display.
Turn off the alarm
Press POWER to turn off the alarm. The alarm will come on again at the set time on
the following days.
Snooze function
This function can be used to stop the alarm temporarily for about 9 minutes once the
alarm is activated. When the SNOOZE button is pressed, the buzzer or radio alarm
sounds will stop and sound again after about 9 minutes.
To cancel the alarm
Press repeatedly AL1 or AL2 until the alarm indicator light goes out on the display.

SLEEP TIMER OPERATION

The sleep function is designed to automatically turn off the Radio.
Setting sleep timer
• Press SLEEP, "90" will illuminate on the display.
• Press repeatedly SLEEP to select the desired sleep time from 90, 80, 70, 60, 50, 40,
30, 20 or 10 minutes.
• The radio will be turned off after the selected time has elapsed.
NOTE: To check remaining sleep time, press SLEEP. To cancel sleep timer, press SLEEP until
"OFF" is selected. To turn off the radio before the sleep time has elapsed, press POWER.
CARE AND MAINTENANCE
Wipe external surfaces with a soft cloth. If the cabinet is very dirty, unplug from the
mains supply and use a damp cloth soaked in a weak solution of washing up liquid and
water. Allow to dry thoroughly before reusing.
EN