Page 6
ENGLISH CORDLESS DRILL/DRIVER DC733, DC740, DC750, DW907 Congratulations! maintained, the vibration emission may differ. This may significantly increase the You have chosen a D WALT tool. Years of exposure level over the total working experience, thorough product development and period. innovation make D WALT one of the most reliable An estimation of the level of exposure to...
ENGLISH Director Engineering and Product Development d Do not abuse the cord. Never use the cord for Horst Großmann carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock.
Page 8
ENGLISH 4 Power tool use and care d When battery pack is not in use, keep it away a Do not force the power tool. Use the correct from other metal objects like paper clips, power tool for your application. The correct coins, keys, nails, screws, or other small metal power tool will do the job better and safer at the objects that can make a connection from one...
Page 9
ENGLISH a Variable speed switch b Forward/reverse slider Do not probe with conductive objects c Keyless chuck d Mode selector/torque adjustment collar Do not charge damaged battery packs e Collar settings f Two gear selector g Ventilation slots Read instruction manual before use h Grip i Battery pack Use only with D...
ENGLISH that the charging process has started. The cable wire colours, or a letter, will be marked at the connection points of most good quality 3. The completion of charge will be indicated by the red light remaining ON continuously. The plugs.
Page 11
ENGLISH READ ALL INSTRUCTIONS However, if the outer seal is broken: a. And the battery liquid gets on your skin, Do not charge or use battery in explosive immediately wash with soap and water for atmospheres, such as in the presence of several minutes.
Page 12
ENGLISH Place the bit in the chuck as far as it will go and Apply only a gentle pressure to the tool. lift slightly before tightening. Excessive force does not speed up Tighten firmly by turning the sleeve clockwise. drilling but decreases tool performance To remove the bit, proceed in reverse order.
Page 13
ENGLISH Drilling in wood Local regulations may provide for separate collection Holes in wood can be made with the same twist of electrical products from the household, at drills used for metal. These bits may overheat municipal waste sites or by the retailer when you unless pulled out frequently to clear chips from purchase a new product.