Table of Contents
Advertisement
Installation and Connection
Dual-Link
DVI Cable (Sold Separately)
5 m or shorter
CONTRO
L
Projector
(*1) Only when connecting it by using "Optical Fiber Cable: EF-FC1150 (50 m: Sold Separately)", it is possible to extend
up to 5 m. The DVI cable when the optical fiber cable (at most 200 m) that is not "EF-FC1150" is used is
recommended to be used by 2 m or less.
1
Connect the video signal source to the
optical transmitter unit (PK-EXT40TG) using
the Dual-Link DVI cable
2
Connect the projector to the optical receiver
unit (PK-EXT40RG) using the Dual-Link DVI
cable
3
Connect the optical transmitter unit
(PK-EXT40TG) to the optical receiver unit
(PK-EXT40RG) using the optical fiber cable
● Align the orientation of the keyway for the optical
fiber cable's plug with that for the connectors of the
optical transmitter and optical receiver units, and
insert it all the way in until a "click" sound is heard.
4
Connect the supplied power cables to the
optical transmitter unit (PK-EXT40TG) and
optical receiver unit (PK-EXT40RG), and
connect the other end of the cables to a
power supply.
Operation
1
Perform installation according to [Installation
and Connection]
2
Turn on the power for the optical transmitter
and optical receiver units
● After connection is established, the AOptB Status
LED on the optical transmitter and optical receiver
units will light up.
Caution:
If AOptB does not light up, check for the following.
● Improper connection of the connectors
: Check the connection.
● Dirt on the connector terminal surface
: Clean the terminal surface.
● Broken optical fiber cable
: Check connection using a different cable.
4
(*1)
Optical Fiber Cable
EF-FC1150G (Sold Separately)
100
l
240
VAC
PK-EXT40RG
Rx Unit
AC 100 V to 240 V
Dual-Link
DVI Cable (Sold Separately)
5 m or shorter
PK-EXT40TG
Tx Unit
Precautions when Connecting Optical Fibre Cable:
● Do not use cables that do not meet the allowable
bending radius. Refer to the instruction manual for the
"Optical Fiber Cable".
● Lay the optical cable ensuring that no heavy objects
are placed on it, no one steps on it, and it is not caught
in the door.
● If a part of the optical cable is subject to stress, protect
the section such as by using a cover.
● After plugging the optical cable into the unit, make
sure that the base of the cable plug is not bent acutely.
3
Turn on the power of the video signal source
● The ASourceB Status LED on the optical transmitter
and optical receiver units light up.
4
Turn on the power of the projector
● The ASinkB Status LED on the optical transmitter
and optical receiver units light up.
● Image appears on the monitor display.
Notes:
● To enhance the service life of the product, prevent the
device temperature from rising too high such as by
adjusting the surrounding temperature or using a fan.
(*1)
Video Signal Source
100
l
240
VAC
AC 100 V to 240 V
Advertisement
Table of Contents
