Table of Contents
Advertisement
Body wall thickness: 16 mm
Screw the mounting pieces to the body on the left
1.
and right.
¨
Remove the tabs from the bottom of the mounting
2.
pieces.
©
Body wall thickness: 19 mm
Fold out the tabs on both of the mounting pieces.
1.
Screw the mounting pieces to the body on the left
2.
and right.
©
Remove the tabs from the bottom of the mounting
3.
pieces.
ª
Preparing the appliance
A handle strip must be screwed to the filter pull-out. This
handle strip can be one that is provided with the
appliance, or one that is available as an accessory.
Use the screws provided to secure the handle strip
1.
to the filter pull-out.
Connect the power cord provided to the
2.
appliance.
¨
Use the strain relief to secure the power cord in
3.
place.
©
¨
5Installation
S liding the appliance up into place
I n s t a l l a t i o n
Slide the appliance up into place and make sure it is
1.
positioned correctly.
Measure the distance between the appliance and
2.
the wall, and mark this on the filler strip.
If required, shorten the filler strip to the required
3.
dimension.
©
Installation
¨
en
13
Advertisement
Table of Contents
