Fujitsu Lifebook E8410 User Manual page 111

Problem
Parallel, Serial, and USB Device Problems
You have installed a parallel
port device, a serial port
device or a USB device.
Your LifeBook notebook
does not recognize the
device, or the device does
not seem to work properly.
PC Card/ExpressCard Problems
A card inserted in the PC
Card or ExpressCard slot
does not work or is locking
up the system.
Possible Cause Possible Solutions
The device is not prop- Remove and re-install the device. See "Device Ports" on page 90.
erly installed.
The device may have Close the application and restart your notebook.
been installed while an
application was running,
so your notebook is not
aware of its installation.
Your device may not See your software documentation and activate the correct driver.
have the correct soft-
ware driver active.
You may have the See your device and software documentation to determine the
wrong I/O address required I/O address. Change the settings in the BIOS setup util-
selected for your device. ity. See "BIOS Setup Utility" on page 54.
Your device and another Check all I/O addresses located within the BIOS setup utility and
device are assigned the any other installed hardware or software to make sure there are
same I/O address. no duplications.
Parallel port is set to Check parallel port setting in the BIOS and set to bi-directional or
output only. ECP.
The card is not properly Remove and re-install the card. See "PC Cards/ExpressCards™"
installed. on page 80.
The card may have Close the application and restart your notebook.
been installed while an
application was running,
so your notebook is not
aware of its installation.
106 - Troubleshooting Your LifeBook