Memory Problems; Modem Problems; Usb Device Problems; Pc Card Problems - Fujitsu Lifebook N3510 User Manual

L i f e B o o k N S e r i e s N o t e b o o k – S e c t i o n S i x
Problem

Memory Problems

Your Info menu of the
BIOS setup utility infor-
mation, does not show
the correct amount of
installed memory.

Modem Problems

Messages about modem
operation.
USB or IR Device Problems
You have installed a USB
or IR device. Your Life-
Book notebook does not
recognize the device, or
the device does not seem
to work properly.

PC Card Problems

PC Card does not work
or locks up the system.
66
Possible Cause
Your memory upgrade module is
not properly installed.
You have a memory failure.
Messages about modem opera-
tion are generated by whichever
modem application is in use.
The device is not properly
installed.
The device may have been
installed while an application was
running, so your LifeBook is not
aware of its installation.
Your software may not have the
correct software driver active.
You may have the wrong I/O
address selected for your device.
Your device and another device
are assigned the same I/O
address.
The card is not properly installed. Remove and re-install the card. (See PC Cards/
The card may have been installed
while an application was running,
so your system is not aware of it.
Your software may not have the
correct software driver active.
You may have the wrong I/O
address selected for your PC Card
device.
Your PC Card device and another
device are assigned the same I/O
address.
The card may have been
"removed" using the Unplug or
Eject Hardware utility.
Possible Solutions
Remove and re-install your memory upgrade
module. (See Memory Upgrade Module on page 41
for more information)
Check for Power On Self Test (POST) messages. (See
Power On Self Test Messages on page 71 for more
information)
See your application software documentation for
additional information.
Remove and re-install the device. (See Device Ports
on page 45 for more information)
Close the application and restart your LifeBook
notebook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the BIOS setup utility. (See
BIOS Setup Utility on page 29 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
ExpressCards™ on page 43 for more information)
Close the application and restart your LifeBook
notebook.
See your software documentation and activate the
correct driver.
See PC Card documentation to determine the
required I/O address. Change the BIOS settings. (See
BIOS Setup Utility on page 29 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
If Unplug or Eject Hardware utility has been used to
remove the card, the system will not recognize it,
even if it is still in the slot. Remove the card and
reinstall it. If that isn't successful, reboot the system.