SPECIFICATIONS Model: DF488D Drilling capacities Steel 13 mm Wood 36 mm Fastening capacities Wood screw 6 mm x 75 mm Machine screw No load speed High (2) 0 - 1,400 min Low (1) 0 - 400 min Overall length 221 mm Rated voltage D.C.
Do not abuse the cord. Never use the cord for WARNING: The vibration emission during carrying, pulling or unplugging the power tool. actual use of the power tool can differ from the Keep cord away from heat, oil, sharp edges declared value(s) depending on the ways in which or moving parts.
Battery tool use and care Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. Use power tools only with specifically desig- nated battery packs.
Do not short the battery cartridge: causing fires, personal injury and damage. It will also Do not touch the terminals with any con- void the Makita warranty for the Makita tool and charger. ductive material. Avoid storing battery cartridge in a con-...
• When the remaining battery capacity gets low: FUNCTIONAL DESCRIPTION If you pull the switch trigger, the motor runs again but stops soon. In this case, to prevent over dis- charge, remove the battery cartridge from the tool CAUTION: Always be sure that the tool is and charge it.
Speed change ASSEMBLY CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit/ drill bit CAUTION: After inserting the driver bit, make sure that it is firmly secured.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. OPTIONAL NOTE: When driving wood screw, pre-drill a pilot hole 2/3 the diameter of the screw.