Table of Contents
Advertisement
ENGLISH
Using the pull out crevice tool (Fig. B,C)
Extend the crevice tool (3) as shown in figure C, until
u
it clicks in place. The push in brush (4) can be fitted if
required for dusting and upholstery cleaning.
To retract the crevice tool (3) press the crevice tool release
u
button (3a) allowing it to return to its normal position
(Fig. B).
Attaching the power head (Fig. D)
Slide the nozzle (2) into the opening of the power head
u
(6), ensuring that the connectors (6a) engage with the
recesses (2a). An auadible click will be heard.
Detaching the power head (Fig. E)
Push th power head release button (6b).
u
Lift the main dustbuster unit from the power head (6).
u
Removing the beater bar from the power head
for cleaning (Fig. F)
Press the beater bar release button (6c).
u
Lift the beater bar (6d) up and out of the power head.
u
The beater bar can now be freed from any hair and accu-
u
mulated debris.
Fitting the handle to the main chassis
(Fig. G, H)
Slide the handle (10) into the main chassis (12) as shown
u
in figure G.
Secure with retaining screw (17) as shown in figure H.
u
Fitting the Dustbuster
(Fig. I, J, K)
Slide the Dustbuster
, nozzle first, into the chassis (12)
®
u
until an audible 'click' is heard as shown in figure I.
To release the Dustbuster
u
chassis release button (11) and lift clear.
The appliance can now be operated via the on/off button
u
(8) on the handle (10) along with the 'BOOST' mode as
shown in figure K. This also allows you to utilise the beater
bars via the 'brush on' control (9).
Removing and clearing the beater bars
(Fig. L, M)
To remove the beater bar unit (13) from the floor head (15)
u
Depress the release button (16) as shown in figure L.
The beater bar (14) can now be removed. The end pieces
u
are also removable allowing you to clear the brushes from
any hair or other debris that may have accumulated (Fig.
M).
Charging (Fig. N, O)
Place the appliance into the charging base (7) as shown in
u
figure N .
10
(Original instructions)
to the Chassis
®
from the chassis press the
®
Plug the charging port (7) into an electrical outlet.
u
Switch the electrical outlet on. The LED charging indicator
u
(B) will Illuminate (Fig. O).
Multi LED Display
A
B
C
A. Filter sensor
Whenever a filter is Blocked and needs cleaning, the red
filter LED (A) in the handle will illuminate.
Clean fine dust from filter (See section on 'cleaning filters'
in this manual).
B. LED Charging display
Battery icon (B) will illuminate when appliance requires
charging. Led display indicates state of charge (See LED
pattern chart in this manual).
C. BOOST mode
Illuminates when the appliance is in BOOST mode
allowing you to operate at higher power.
LED Patterns
Cleaning the filters (Fig. P, Q, R, S, T,
U )
Press the dust bowl release button (18) (Fig. P)
u
Eject the dust bowl (5) (Fig. Q)
u
Charging
Battery Fault
Charger Fault
Battery Hot
Advertisement
Table of Contents
