Advertisement
CLASSIFICATION
SUBJECT
CUSTOMER'S CODE
PAN9320ETU
Windows device manager hardware settings you have to figure out which one is the
port for Uart0.
To make it more comfortable you can install the following driver that gathers both FTDI
ports to one virtual port.
Download the libusb-win32 v.1.2.6 for free (third-party).
The commands can be send via the Command Interface are described in the DS-CS-
CommSpec-9320.
To test the Command Interface via USB0 you could use a terminal program like
HTerm.
Standard configuration USB0/1:
Port: your virtual ComPort
Baudrate: 115200
Databits: 8
Paritybit: none
Stopbits: 1
If your connected, try to send "get system firmware" to request the firmware version of
the module.
Be sure you send the request followed by CR-LF as described in the communication
specification.
The answer should be received like in the received window of the HTerm-based
example below.
4.
Activate your WLAN-device on your PC. It should start scanning for new wireless
devices in your near environment.
You should see the SSID PAN9320_AP in your list as it is broadcasted by PAN9320.
The standard connection is protected by WPA2 key.
Quick Start Guide
PAN9320ETU
PANASONIC'S CODE
PAN9320ETU
No.
DS-SG-QSG-9320ETU
PAGE
3 of 5
DATE
28.04.2015
REV.
0.1
Advertisement
