Using Your Tv; Status Light - Sharp LC-55LB481U User Manual

Scanning for channels can take several minutes.
Tip
Repeat the channel scan from time to time to make sure you are receiving all of the
latest channels. Broadcasters add and remove channels, move channels to different
parts of the spectrum, and change the power levels of their channels periodically.
Note
You'll have to repeat the channel scan if you remove the Antenna TV tile from the
Home screen or perform a factory reset. To repeat the channel scan at any time, go to
Settings > TV inputs > Antenna TV > Scan again for channels. Your antenna
reception and picture quality depend on the position of your antenna and on your
location relative to the antennas of broadcasters in your area.
Now, you're ready to watch broadcast TV! While you're watching, try the following:
• Press the UP and DOWN arrows to change channels.
• Press the LEFT arrow to display the channel list and then use the UP and DOWN arrows to select a channel to watch. Or
press REWIND or FAST FORWARD to jump through the channel list a page at a time.
• Press OK to display information about the current program.
• Press to switch to the previously tuned channel.
• Press to see options for picture and sound settings.
Note
If
Jump Back button on a universal remote. For more information, see
page 71.
Remote control
buttons while watching TV.

Using your TV

This section provides information on using the day-to-day features of your TV.

Status light

Your TV has a single status light on the front panel. It goes on and off and blinks in different ways depending on the status of
the TV, as shown in the following table:
TV condition
On (screen is active)
Screensaver (screen is active,
except when the Picture
Mode is set to Low power.
Low power turns off the
backlight.)
Off (no power)
Off (standby)
Starting up from off state
On (receiving update from
USB)
Remote control command
received
Powering down to standby
mode
is not available on your remote control, you can use
on page 13 has more information on using the remote control
Status indicator
Off
Off
Off
On
Slow pulsing blink until
startup completes
Slow pulsing blink until
update completes
Dims on/off once
Slow pulsing blink until
the TV reaches standby
LC-55LB481U 55" Full HD LED 1080p Sharp Roku TV
on the Roku App or the
Other devices
Meaning
Screen is indicating that your TV is on.
Screen is indicating that your TV is on.
Your TV is not connected to power.
Your TV is connected to power and ready
to use.
Your TV is doing something.
Your TV is doing something.
Your TV has received your command.
Your TV is doing something.
on
45