Quality; Information Label; Product And Catalog Serial Numbers; Remove Circuit Breaker From Container - ABB Emax 2 Installation And Maintenance Manual

17 -Quality

All Emax 2 Retrofill circuit breakers have been designed and manufactured to ANSI
standards. The design was based on the original requirements of the Legacy Switchgear
and Breaker. The product is assembled by ABB Inc USA (Senatobia,ms) and is inspected
using some of the same master gauges used on the legacy AK, AKR breakers to confirm
electrical and mechanical performance, including rejections-feature

18 - Information Label

On the front of each circuit breaker there is a factory-assembled label that details all
electrical accessories included on the circuit breaker.

19 - Product and Catalog Serial Numbers

Product and catalog serial numbers should be kept handy when communicating about the
circuit breaker. Each circuit breaker has a unique serial number located on the front side of
the fascia.

20 - Remove Circuit Breaker from Container

Inspect and 1. Inspect the shipping container for obvious signs of rough handling and/or external
Prepare damage incurred during transportation.
2. Record any observed damage for reporting to the carrier. Ensure all recorded reports
and claims include the order number and name plate information.
3. Remove the banding straps and lift off the top cover.
4. Remove all packaging material.
5. Remove all product documentation and store properly.
Unscrew the mounting screws that fasten the circuit breaker to the bottom of the shipping
pallet and remove the circuit breaker or cassette.
Use Lifting Device 1.
2.
3.
4.
5.
6.
7.
For detail procedure to Rack in and Rack out Emax 2 breakers refer operating instruction
document 1SDH001330R0002 provided in the box
2TSA451011P0000 Rev-B
Use a lifting device to lift and mount the cassettes and circuit breakers to avoid
personal injury or damaging the devices.
NOTE: Emax 2 frame 1.2 has no lifting bar. Lift with 2 people to install into cassette.
Contact the nearest sales office for availability of a hoisting device or contact ABB post
sales service 888-437-3765.
2000A Breakers : Lifting Bar 2TSE431929R1000
Lifting bars are available from ABB Inc USA.

AK Retrofill breakers use the Emax 2 & Emax 2 Retrofill lifting device.
Position the lifting plates on the Emax 2 drawout circuit breaker making sure that
tongue of the plates is latched properly as shown (Figure 46).
Extract the rails for loading the circuit breaker using appropriate levers in figure 47.
Position the breaker on the rails as shown in figure 48.
After dropping the circuit breaker on to the guides unlatch the tongue and remove the
lifting plates as shown in figure 49.
© 2020 Emax 2 Retrofill Circuit Breakers 600A-4000A | 21