Placing Headsets In Pairing Modes - Honeywell A700 Hardware Reference Manual

Because the device is the initiator and the headset is the acceptor, a user facilitates the pairing
process by putting the headset into pairing mode before initiating the connection from the
device.
SRX2 and SRX3 headsets support three pairing modes.
Low Power Pairing Mode
l
Low power pairing mode is the default pairing mode for SRX2/SRX3 headsets. In this
mode, a headset will answer a Bluetooth device inquiry with a very low power response that
transmits within a small area (a few feet or so, depending on the receiving capabilities of
the inquiring device).
Limiting the wireless transmission helps to avoid an unwanted cross pairing (a pairing with
a Bluetooth address other than the target) by forcing the headset to be in close proximity to
the device.
High Power Pairing Mode
l
High power pairing mode allows the headset and device to be separated by more distance
because the headset's response to inquiries is a wider transmission.
Honeywell recommends using high power pairing only if low power pairing fails. Use this
mode with care: While high power pairing mode makes it more likely that the connection
will succeed, it also increases the likelihood of cross pairing.
If the configuration parameter SrxAutoPairEnable is enabled and the configuration
parameter SrxHighPowerPairingDelaySeconds is set to 0, headsets will skip lower power
pairing mode and enter high power mode.
TouchConnect
l
You can pair an A700 or A700x device and an SRX2 or SRX3 headset by touching them.
This method essentially eliminates the chance of cross pairing and it is quicker and easier
than the other methods.

Placing Headsets in Pairing Modes

Initial Headset
State
Off
On and paired
On in low power
pairing mode
133
SRX2/SRX3 Controls
Press and release Power
button
Press and release Plus (+)
and Minus (-) buttons
Press and release Plus (+)
and Minus (-) buttons
Pairing Mode Result
Low power pairing mode
Current pairing broken and headset
enters low power pairing mode
High power pairing mode
Voice Device and Headset Hardware Reference Guide