Using the Still Picture Recording Function Linked to an External Device
By combining various sensors and switches to operate according to External Device Input settings,
it is possible to build a monitoring system that responds to external events. Still pictures are
recorded in the VB-C10/VB-C10R's memory (→ P.3-16).
Sample Application Combining a Door-opening Sensor
This is a monitoring system in which the VB-C10R installed in the ceiling records pictures every
second for 3 seconds before the doors opens and 7 seconds after the door opens between 5 p.m.
and 6 a.m. The equipment shown in the figure below is connected to the terminals on the rear of
the VB-C10R at installation.
○ ○ ○ ○ ○ ○
Installation Example
Sensor A
When the door opens and sensor B mounted on it separates from sensor A, an ON event occurs
at external device inputs IN
the entrance and stores them.
○ ○ ○ ○ ○ ○
VB-C10R Connection Example
Connector
+
–
IN
, IN
Sensors mounted on the door
Remove some insulation at the end of the cables from the sensor and
insert them into the IN
device. Then tighten the screws on the plug to secure the cables.
Insert this plug with the cable into the external device I/O jack on the rear of the VB-C10R.
Please confirm the Date and Time settings on page 3-10.
Note
6-2
Sensor B
+
–
and IN
. In response to this event, the VB-C10R records pictures at
Attached Cable
+
and IN
–
terminals on the plug for the external
VB-C10R
Ethernet
–
+
IN
IN