Canon VK-64 Administrator's Manual page 89

If you have a Multi-Terminal Module VB-EX50 unit plugged into a
VB-C50i/VB-C50iR, VB-C50FSi, VB-C50Fi and have configured the
Tip
"Use External Video Input", video seen in the Viewer may be
taken from cameras connected to the Multi-Terminal Module.
Switch the video at the Admin Viewer as required.
●
Selecting the Storage Server
If you do not want the Camera Server to record video, select Do not record from
2
the drop-down menu of Storage Server.
Recording schedules must be set in order to record video.
There is a maximum number of 64 Camera Servers that can be
Note
registered on one Storage Server with VK-64 (or 16 cameras
with Network Video Recorder VK-16).
If you are using the Viewer only, the Storage Server cannot be
configured.
If you have changed the Camera Server's IP address, you also
need to change the host names in the Connection Settings
and Storage Server Settings dialogs.
●
Configure External Device Input
Registering Camera Server
Select a Storage Server from the
1
drop-down menu which lists pre-
configured Storage Servers and
enter the Host Name or IP
address in Host Name or IP and
Port number in Port.
The Host Name or IP must be
255 characters or less (each label,
separated by a period, must be 63
characters or less) and the Port
number must be a figure within the
range from 1 to 65535.
To switch On or Off the external device
input, check the Invert the state of the
following external option.
One or more inputs may show depending on
the type of the Camera Server. It is not
necessary to change this setting if it is not
required.
4
89