General Terms For Press Operating Modes - Bosch Rexroth IH04 Manual

52/56 Press modules Type IH04 | Glossary
Bosch Rexroth AG, Edition 08.2021, RE 63124-B

17.3 General terms for press operating modes

Function
Operating sequence of a machine or part of a machine, which is specific or
required for the execution of an intended machine task.
Operating mode: automatic mode
Operating mode in which the press slide movement is repeated permanently or
intermittently; all functions are executed after the start command without manual
intervention in the hazardous area.
Operating mode: automatic mode with AOS, single interruption
Operating mode in which the press slide movement is repeated intermittently;
all functions are executed after the start command without manual intervention
in the hazardous area. The cycle is initiated after clearing the AOS after a single
interruption (e.g. for manual loading and unloading).
Operating mode: automatic mode with AOS, double interruption
Operating mode in which the press slide movement is repeated intermittently;
all functions are executed after the start command without manual intervention
in the hazardous area. The cycle is initiated after releasing the AOS following
a double interruption (e.g. for manual loading and unloading).
Operating mode: OFF
Operating mode in which the press is put out of operation.
Operating mode: set-up/jog mode (setting, inch, jog)
Operating mode for the purpose of installation or removal of dies, adjustment of
dies, technical protective measures and other devices, as well as cleaning,
inspection and maintenance, where the risks associated with the press slide
movement are reduced accordingly by the permanent operation of a control
device by the operator and technical protective measures to limit the press slide
movement (for example, a slowed movement or interrupted movement of the press
slide).
Operating mode: single stroke mode and/or test stroke
Operating mode for single cycle mode with manual loading and unloading.
With test stroke, the movement includes the press slide functions but not
the movement of the additional devices (e.g. transfer system), which must be
started separately.
Working cycle
Complete motion sequence of the press slide and other components of the press
used for production (e.g. die cushion, workpiece ejector) including the supply
and removal of material or the workpiece; in the case of hydraulic presses along
a programmed movement sequence from a start position until the same position is
reached again.