Bosch DWK0.5G.0 User Manual And Installation Instructions page 13

12.9 Instructions for the air extraction mode
For air extraction mode, a one-way flap should be in-
stalled.
Notes
¡ If a one-way flap is not included with the appliance,
one can be ordered from a specialist retailer.
¡ If the exhaust air is conveyed through the external
wall, a telescopic duct should be used.
12.10 Information about circulating-air
mode
The appliance must only be operated when it is se-
curely installed and the pipework is connected.
12.11 Installation
Checking the wall
Check whether the wall is vertical and has sufficient
1.
load-bearing capacity.
The maximum weight of the appliance is 16 kg.
Drill the hole depth in accordance with the length of
2.
the screws.
The wall plugs must have a secure grip.
The enclosed screws and wall plugs are suitable for
solid brickwork. Suitable fasteners must be used for
other structures (e.g. plasterboard, porous concrete,
poroton bricks).
Preparing the wall
Ensure that there are no electrical wires, gas pipes
1.
or water pipes in the area where holes are to be
drilled.
Cover the hob to prevent damage.
2.
Mark a vertical centre line on the wall from the ceil-
3.
ing to the lower edge of the appliance.
Centre the angle brackets using the centre line.
4.
The centre of the angle brackets is marked with a
notch.
Align the angle brackets horizontally.
5.
Mark the holes for the angle brackets in the flue.
6.
Mark the holes for the appliance bracket.
7.
Drill the holes.
8.
Insert the wall plugs flush with the wall.
9.
Screw on the angle bracket for the flue duct.
10.
Screw in the screws for the appliance bracket
11.
loosely; do not tighten them fully.
Preparing the appliance
Open the filter cover if required.
1.
Remove the grease filters.
2.
Installation instructions en
13