GE SHARPSHOOTER 6150-ID Installation Instructions Manual

g
Figure 1. Exploded view
Swivel mounting bracket
Two #6 x 3/4"(2cm) screws for
mounting the bracket or case
(Two #6 wall anchors are
included for sheet rock mounting)
Description
The 6150-ID (Figure 1) is an addressable PIR device that
interfaces with the PinPoint system. This system provides
flexible and reliable two-way communication between the
device and the controller.
Mounting location
Avoid false alarm sources (Figure 2)
The unit should not "see" sources of heat or cold. For
false alarm free operation, no part of an unwanted hot
spot should enter any part of a zone.
Locate for cross traffic (Figure 3)
Place the unit where intruders move across the beams,
not toward the unit. For best detection, an intruder
should cross the entire zone.
Do not block the coverage pattern (Figure 4)
The unit requires a clear line of sight. Inform end-users
not to block the coverage pattern with inventory or
furniture.
Figure 3. Cross traffic
6150-ID SHARPSHOOTER
installation instructions
Base
15
10
5
0
5
10
10
5
10
5 0
Mounting knockouts #8 x 3/4"(2cm) screw
for ball joint shoe
Lens shield/circuit
Standard lens
board assembly
(Masking kit included)
Front cover
LED
Figure 2. False alarm sources
Hot or cold air directed
onto sensor
Pets
Figure 4. Blocking coverage pattern
™
PIR
Sliding LED cover
Sunlight or
reflected sunlight
Windows
Intermittent
heat sources