Miele EVS 7010 Operating And Installation Instructions page 58

Installation
Aligning the front of the drawer
After installing the combination appli-
ance, it may be necessary under certain
circumstances to align the front of the
drawer and adjust the gap between the
drawer and the combination appliance.
For this purpose, 2 screws can be
found behind the front of the drawer
which are used to fasten the front to the
housing of the drawer.
 Open the drawer.
 Loosen the retaining screws  on the
right and left of the drawer housing.
Do not remove the screws com-
pletely, as the front may fall off.
 Push the front of the drawer up or
down a little to correct the alignment
and the gap.
 Tighten up the retaining screws.
58