System Setup - Canon imagePROGRAF IPF9100 User Manual

Control Panel

System Setup

Warning
Keep Media Size
Paper Size Basis
Noz. Check Freq.
Sleep Timer
56 Printer Parts
Setting Item
Buzzer
Detect Mismatch
Skip Take-Up Err
Sht Selection 1
Sht Selection 2
Description, Instructions
Set the buzzer. Choose On for the buzzer to sound once
for warnings and three times for errors.
Choose Warning for notication (display of a warning
message) during printing if the paper type specied in
the printer menu does not match the paper type in the
printer driver. Choose None to continue to print without
notication. Choose Pause to have printing paused under
these circumstances. In this case, you can continue
printing by pressing the Online button.
Choose On to continue with printing even if an error occurs
with the Media Take-up Unit . Choose Off to have the
printer pause before printing if a rewinding error occurs.
Choose On to use the paper size setting as the basis for
printing instead of other settings. The margin setting of the
printer menu will be used instead of the margin setting of
the printer driver if the latter is smaller, which may prevent
text or images in the margin from being printed.
Choose Off to use the printer driver settings instead. Even
if the margin setting of the printer driver is smaller than
that of the printer driver, text or images will not be cut off.
However, this requires longer paper because the actual
margin will be equal to the margin setting of the printer
driver plus the margin setting of the printer menu.
If sheet size detection is activated, choose whether ISO
A3+ or 13"x19"(Super B) is applied when an intermediate
size is detected.
If sheet size detection is activated, choose whether ISO
B1 or 28"x40" (ANSI F) is applied when an intermediate
size is detected.
Specify the timing for automatic checks of nozzle clogging.
Choose 1 page to check once per printed page. Choose
10 pages to check once per ten printed pages. Choose
Automatic to have the printer automatically adjust the
timing for checks based on the frequency of nozzle use.
Specify the period before the printer enters Sleep mode.