Toro DH 200 Series Installation Instructions

Belt Guard Kit
DH 200 Series Lawn Tractor
Model No. 120-1190
Do not supply these instructions to the customer.
These instructions are for a dealer to install additional belt guards mandated by the French government.
Safety
Safety and Instructional
Decals
Safety decals and instructions are easily
visible to the operator and are located
near any area of potential danger.
Replace any decal that is damaged or
lost.
120-1119
1. Fire hazard—read the Operator's Manual.
© 2011—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Installation
1
Preparing for Installation
No Parts Required
Procedure
Important: Refer to the Operator's Manual if you
are unfamiliar with the specifics of operating this
machine before proceeding. The manual contains
important information about safely operating the
machine. If you do not know this information, you
could seriously injure yourself or others.
1. Park the machine on a level, smooth surface with
sufficient space to access both sides of the mowing
deck.
2. Lower the mowing deck to the shortest cutting
height.
WARNING
Before working on the machine, stop the engine,
set the parking brake, remove the ignition key,
and disconnect the spark plug wire.
CAUTION
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect
the wire from the spark plug before you do any
maintenance. Set the wire aside so that it does
not accidentally contact the spark plug.
3. Support the rear axle on both sides and remove both
rear wheels.
Register at www.Toro.com.
Form No. 3368-455 Rev A
Installation Instructions
Original Instructions (EN)
Printed in the USA.
All Rights Reserved