Recording tips (continued)
To change the trigger level for Level
Synchro Recording
Perform the following procedure to change the
signal level that triggers Level Synchro
Recording.
1
Press FUNCTION repeatedly to switch the
function to MD.
2
Press MENU/NO on the remote repeatedly
until "Setup Menu" appears.
3
Press . or > for the MD until "LS(T)"
appears, then press ENTER/YES on the
remote.
4
Press . or > for the MD to select the
level, then press ENTER/YES on the
remote.
You can set the level at any value between
–72 dB and 0 dB, in 2 dB steps.
5
Press MENU/NO on the remote.
Marking track numbers at a specific
point during recording
— Track Mark
You can mark track numbers at any time during
manual recording, regardless of the type of
sound source.
Press MD REC z during manual recording at
the point you want to add a track mark.
The tracks following the added one are
renumbered.
GB
22
Making a space between
tracks 3 seconds long
— Smart Space
Smart Space: Lets you make the blank
spaces between tracks 3 seconds long
automatically while recording. If the Smart
Space function is on and there is no sound
input for about 3 seconds or more (but less than
30 seconds) while recording, the MD deck
replaces this silence with a blank of about 3
seconds and continues recording.
No sound input for less than 30 seconds
Off
On
Replaced with a blank of 3 seconds and
recording continues
Auto Cut: When the Smart Space function is
on, if there is no sound input for 30 seconds or
more, the MD deck replaces this silence with a
blank of about 3 seconds and enters recording
pause.
No sound input for 30 seconds or more
Off
On
Replaced with a blank of 3 seconds and
recording pauses