Table of Contents
Advertisement
3-2-1. Cleaning the Gate Base (35) assembly
Removing
1. Set a unit in the STANDBY OFF mode.
2. Turn off the power.
3. Release the two one-touch fixing screws with turning
90 degrees counterclockwise, pull the gate base (35)
assembly in the direction of arrow, then remove it
from the guide pin.
One–touch fixing screws
Guide pin
Sprocket
Gate base (35)
assembly
FVS-1000 MMP1
http://getMANUAL.com
4. Remove the adherence with air etc.
5. Clean the top of the gate with the cleaning cloth to
6. Wipe the cleaned surface with a dry cloth two or three
Film position fixing supports
Installing
n
When installing, be careful not to hit the gate base against
the sprocket.
7. Install the gate base (35) assembly in the reverse order
Guide pin
Sprocket
which the cleaning fluid is applied.
times.
Cleaning
Cleaning
Clean
of removing procedure 1 to 3.
[Reference]
When the groove (_) of the one-touch fixing screw is
almost horizontal, the assembly is fixed.
3-2. Cleaning the Running System
Gate base (35)
assenbly
Film support
assenbly
Film position
fixing supports
3-3
Advertisement
Table of Contents
