D/A Video Level Adjustment - Sony MAV-555 Maintenance Manual

4-5-2. D/A Video Level Adjustment

m
Check the following setup menus before starting adjust-
ment.
. Check the NTSC/PAL setup. (Refer to menu No. 010 of
Section 1-9-2 of the MAV-555 Installation Manual.)
. Check the network setup. (Refer to menu No. 220 of
Section 1-9-6 of the MAV-555 Installation Manual.)
Connection
MAV-555 + BKMA-512
Ethernet
PC
* : Connect to the VIDEO OUT P1-A or the VIDEO OUT P2-A in
accordance with the port to which the BKMA-512 is connected.
MAV-555
http://getMANUAL.com
Setting
1. Open "782-INT VD SG R1" of the setup menu.
n
For details on how to use the setup menu, refer to the
Operation Manual.
2. Press the VIDEO/MENU knob once.
3. Turn the VIDEO/MENU knob and select "CB100"
(100% color-bar signal).
*
VIDEO OUT
P1-A
or
P2-A
ETHER
4. Press the SET button.
5. Set "703-OUT SETUP P1" or "704-OUT SETUP P2"
to "off" on the setup menu in accordance with the port
that the BKMA-512 is connected to. (Refer to Section
1-9-5 of the MAV-555 Installation Manual.)
Waveform monitor
or an oscilloscope
n
The setting is not required in case of the 625-mode
(PAL).
6. Turn off the main power and back on. Restart the
MAV-555.
n
To restart the MAV-555 quickly, execute "027-FAST
REBOOT" of the setup menu.
7. Press the R1 button on the PORT SELECT block of
the meter panel.
(Set so that the internal SG is output to the R1 port.)
8. Press the COMPOSITE button of the VIDEO INPUT
SELECT block of the meter panel for at least three
seconds. (The internal SG starts, and the COMPOSITE
button and the SDI button are turned on.)
9. Press either the P1 or the P2 button of the PORT
SELECT block of the meter panel in accordance with
the port to which the BKMA-512 is connected.
10. Press the CONTROL button of the VIDEO PROCESS
block on the meter panel several times, and enter the
LOCAL mode.
11. Set all buttons of VIDEO, CHROMA, SETUP, and
CHROMA PHASE on the meter panel to "PRESET".
782-INT VD SG R1
782-INT VD SG R1
4-5. DA-136 Board Adjustment
off
CB100
4-11 (E)