Fap-425-Dot-R / Fap-425-Ot-R / Fap-425-Ot - Bosch AVENAR 4000 FAP-425-O User Manual

AVENAR detector 4000
Selectable installation locations in
the programming software
(FSP‑5000‑RPS)
High storage warehouse without
vehicle traffic with combustion
engine
Conference hall/waiting room/
fairground
Kitchen/casino/restaurant during
active operation
Warehouse with vehicle traffic
Rate of rise only (optical sensor off) T
Optical only (thermal sensor off)***
Fixed temperature heat only
(optical sensor off)
Optical/chemical (thermal sensor
off)***
Schools/kindergarten
Theater/concert hall
O = optical sensor
T = thermal maximum unit
max
T = thermal differential unit
diff
C = chemical sensor
* If optical sensor sensitivity is low, the detector will only trigger if smoke as well as an increase in CO
concentration or temperature is detected.
*** For FAP-425-DOTC-R: does not comply with EN54-7
FAP-425-DOTC-R complies with EN54-29 if optical sensitivity is fully set to medium or high.
4.2 FAP‑425‑DOT‑R / FAP‑425‑OT‑R / FAP‑425‑OT
Notice!
i
The default setting of the FAP-425-DOT-R, FAP-425-OT-R and FAP-425-OT detector types in
RPS is "Office (day mode)". For a description of this setting, see the below table.
Selectable installation locations in
the programming software
(WinPara and FSP‑5000‑RPS)
Office (after hours)
Office (smoker)/waiting room/
restaurant/meeting room
Office (day mode)
= default setting
Bosch Sicherheitssysteme GmbH
Detector Type Sensitivity
Temperature (T)
O, T , T , C Low (BR)
max diff
O, T , T , C High (A2R)
max diff
O, T , C Low (BS)
max
O, T , T , C Low (BR)
max diff
, T High (A2R)
max diff
O -
T High (A2S)
max
O, C -
O, T , T , C High (A2S)
max diff
O, T , T , C High (A2R)
max diff
Detector Type Sensitivity
Temperature (T)
O, T , T High (A2R)
max diff
O, T , T High (A2R)
max diff
O, T , T Low (BR)
max diff
User manual
Programming | en
Optical (O) Chemical (C)
High High
Low* Medium
Low* Low
Low* Low
- -
Low -
- -
Low High
Medium High
Medium High
Optical (O)
High
Low
Medium
2021-11 | 4 | F.01U.283.550
13