Front Panel And Tray; Rear Panel - Mitsubishi Electric DD-8020 Service Manual

B
Tray panel (4)
A
Tray (3)
Fig. 2-1-5

1-1-4. Front Panel and Tray

1. Remove the flexible cable (1).
2. Remove one screw (2) and remove the GND lead (5).
3. Release four claws and remove the front panel (4).
4. Pull out the tray (3) to this side.
Screw (2)
GND lead (5)
Claw
Tray (3)
Front
panel (4)
Claws
Fig. 2-1-6
Note:
• Insert the tray (3) with the front side of the pickup
mechanism assembly descended. (The slider positions
to the left side.)
• The gears are required to match their phases each
other. After setting the gear (4) as shown in the figure
"A", insert the tray (3). When inserting a tray (3), push
the rack gear side shown by the arrow.
Tray (3)
Tray panel (4)
Claws
Flexible cable (1)
• Confirm that the mark of the gear matches with the
triangle mark on the reverse side of the tray in the tray
close status. (The gear is rotated with the slider locks.)
(Refer to Fig. B.)
Gear (4)
Tray rack gear
Marking
Gear (4)

1-1-5. Rear Panel

1. Remove eight screws (1) and remove the rear panel (2).
2-3
Fig. A
Triangle mark
Position of the line
Pickup mechanism
assembly
Gear (4)
Slider
Tray (3)
Triangle mark
Fig. B
Fig. 2-1-7
Screws (1)
Rear panel (2)
Fig. 2-1-8