Entering Global System Data - GE DigitalFlow DF868 Programming Manual

Entering Global System
Data
Programming Site Data
While following the programming instructions, refer to the menu map
in Figure A-5 on page A-5.
GLOBAL
1. To enter the menu, press
SYSTM
2. To enter the submenu, press
3. At the System Units prompt, press
measurements in English units or press
and measurements in metric units.
4. At the Totalizer Option, press
[F2]
or press to measure totals manually.
AUTO
If is selected above, the meter automatically begins totalizing
upon leaving the User Program. If
on the keypad may then be used to start and stop the totalizer.
The manner in which the totalizer responds to an error condition may
I/O
be set in the submenu.
5. Use the [←], [→] and
Volumetric Units for the flow rate display.
Note: The above option bar shows English units, as an example.
The abbreviations and definitions of all the available volumetric units
are shown in Table 1-15 on page 1-42. The choices shown on the
option bar are determined by the selections made at the previous
System Units prompt screen.
[F3]=GLOBL.
[F2] SYSTM
=
[F1]
to display parameters and
[F2]
to display parameters
[F1]
to measure totals automatically
MNUAL
is selected, the console key
[F1]-[F4]
keys to select the desired
March 2008
.
1-41