Carry In Machines & Equipment And Level The Machine; Confirmations Before Carrying-In; Unload The Machines And Equipment - Yamaha S20 Service Information

3. Carry in machines & equipment and level the machine

3.1 Confirmations before carrying-in

A transport company will bring the machine to the customer's site by truck, etc.
The followings are the required confirmations before unloading the machines or equipment from a truck.

Make sure there is no damage to the machine.
If any damage, dent or deformation caused during transportation found on the machine, have the
transport company check the situation out, and
as evidence (taking pictures using a cell phone is fine).
take proper measures.

Make sure that all the requirements for installing the machine have been delivered to the
installation site.
If the requirements for installing the machine have not been delivered to the installation site, inform the
transport company immediately and have them to ship the items by other truck.

Check the external temperature.
If the external temperature is low, condensation may occur. Explain this to the customer and ask them
to prepare the place to temporarily locate the machine (the difference between the external
temperature and the temperature in the installation site must be 10 degrees C or less).
Rent a stove, etc., and gradually warm up the machine. Carry in the machine after confirming that the
base of the machine temperature rises 5 degrees C.
Caution:
Condensation may occur on the machine when the difference between the external temperature and the base of
the machine temperature is

Make arrangement with the customer regarding the installation of the machine beforehand.
Make final checks if the installation of the machine, the electric work and the work for air supply are
going to be performed as
on the customer).

3.2 Unload the machines and equipment

Normally a transport company unloads the machine from a truck using a forklift, etc.
Caution:
When the machine is on a truck, confirm that the supporting legs (locating in the bottom center of S20 and M20)
are raised.
Carry in the machine that was unloaded from a truck to the installation site by operating a transport
equipment such as a hand lifter, etc. Make sure to follow the precautions below.

Precaution when operating a forklift
When the machine is packed, the notice is labelled as shown in the figure below to avoid the fork of the
forklift and the cover of the machine from interfering with each other.
Do not insert the fork into the labelled part as the cover, etc., may be damaged.
S10, M10
See "5.1
Unload the machine by suspending" for unloading the machine operating a unic.
10 degrees C or more.
scheduled, and the
S20, M20
SI1604009E-002= S20, S10, M20, M10 and D10 installation procedures
Service Information
take some pictures of the damaged part on the spot
Also let the customer know immediately to
safety precautions (as the regulations vary depending
5/34
For Service Engineer