Preparations
Settings on the Control Terminal
Before switching signals with this unit, the following
preparations must be made on the control terminal
connected to the primary station of the S-BUS data link.
Preparations for the MKS-8080/8082
Setting the station number
Set the station number using source select buttons
[8]
. The station number is obtained by adding the binary
place values of the buttons that are lit.
Button No.
[1]
Button
[2]
Button
[3]
Button
[4]
Button
[5]
Button
[6]
Button
[7]
Button
[8]
Button
Example:
[1]
[2]
If buttons
,
, and
(1 + 2 + 8).
For the button numbers, see "Initializing the settings".
Note
Do not assign the same number to more than one unit in a
control system.
1
Press and hold the X-HOLD button (MKS-8080) or
XPT HOLD button (MKS-8082) and LOCK (CHOP)
or KEY button together for about 5 seconds until
Reset appears in the Preset display window to restart
the unit.
2
During restarting (lighting statuses of the buttons are
being checked), press and hold source select buttons
[1]
[2]
[3]
[4]
,
,
, and
mode.
Note
When the power is turned ON for the first time,
station number setting mode is automatically
activated, and steps 1 and 2 are not required.
18
Preparations
Input value
Unlit
Lit
0
1
0
2
0
4
0
8
0
16
0
32
0
64
0
128
[4]
are lit, the station number is 11
to enter station number setting
3
Press the appropriate source select buttons or turn the
SELECTOR knob so that the desired station number
is obtained.
The ID number will appear in the Preset display
window in the format ID = xxx.
4
Press the ASSIGN button (MKS-8080) or ASGN
button (MKS-8082).
The set station number is registered
[1]
to