Advertisement

Quick Links

Universal Remote
SRP6011
TAPR802
User manual
Register your product and get support at
www.philips.com/support

Advertisement

Table of Contents
loading

Summary of Contents for Philips SRP6011

  • Page 1 Universal Remote SRP6011 TAPR802 User manual Register your product and get support at www.philips.com/support...
  • Page 2: Table Of Contents

    Contents 1 Your universal remote Introduction Overview of the universal remote 2 Get started Insert batteries (not included) Set up the universal remote 3 Use your universal remote control Learning 4 Notice Disposal of your old product and battery 7 5 Service and support Frequently asked questions Need help?
  • Page 3: Your Universal Remote

    FAV: access the favorite channel list. OPTIONS: access the options menu. Congratulations on your purchase, and AUDIO: select the audio channel. welcome to Philips! To fully benefit from the : stop support that Philips offers, register your product : pause at www.philips.com/welcome...
  • Page 4: Get Started

    2 Get started Set up by code selection Switch on your device. Insert batteries (not included) Press and hold at the same time for 5 seconds until the red LED is on. Warning • Check the battery polarity when inserting in the battery compartment.
  • Page 5 Enter the first 5-digit code using the digit Auto registration buttons. Switch on your device. If the light is off, a valid code is saved. Otherwise, the light will flash six times, and Press and hold at the same time then remains on for code re-entry.
  • Page 6 LIST AUDIO HOME SMART When the device is off, immediately press TREBLE and release OK to save the code.The blue BASS BASS TREBLE LED indicator will turn off. MENU BACK max. 20 minutes Operate the device with the universal remote. If your device responds correctly, it means you have saved the right code.
  • Page 7: Use Your Universal Remote Control

    3 Use your Note universal • On step 4, if no key is selected for more than 15 seconds, the LED indicator will flash six times and the remote control learning mode will exit automatically. • On step 5, if no other remote signal is received for more than 30 seconds, the LED indicator will flash six times and then remains on.
  • Page 8: Notice

    4 Notice Removing the disposable batteries To remove the disposable batteries, see section ‘Insert batteries’. Disposal of your old product When this logo is attached to a product, it and battery means a financial contribution has been paid to the associated national recovery and recycling system.
  • Page 9: Service And Support

    If, however, you require extra information or have additional questions about setup, usage, warranty, etc of the SRP6011, you can always contact us. When calling our helpline, make sure to have the SRP6011 at hand when you call, so that our...
  • Page 10 Specifications are subject to change without notice. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product.

This manual is also suitable for:

Srp6011/10

Table of Contents