Toshiba e-STUDIO2010AC User Manual page 14

No. Inspection item
12 SATA I/F &
SMART
13 USB Host
14 USB Fax
15 Scan Control
16 LGC
Communication
17 SLG
Communication
*1. Here shows the
installed status of
the DF (No
ADF, RADF,
DSDF)
*2. Although it may
be displayed as
"WARMUP", it is
reference
information.
(Continued on next page)
Inspection result
NG [LINK DOWN]
NG [SPD]
NG [SMART]
NG [ID]
OK?
OK?
OK? [No fax
detected]
NG
NG
NG [LGC_EN]
NG [C900]
NG [C963]
NG [LGC_Reset] Replace the SYS board.
NG<DF*1>*2
NG <DF *1>
[SLG_EN] *2
NG <DF*1>
[C260] *2
NG <DF*1>
[C261] *2
NG <DF*1>
[C262] *2
NG <DF*1>
[C270] *2
14
Correspondence
Step 1. Check the installation status of the
HDD harness.
Step 2. Replace the HDD harness.
Step 3. Replace the HDD.
Step 4. Replace the SYS board.
Replace the HDD.
Replace the HDD.
Number of USB device connections
(NG will not be displayed)
Number of fax connections
(NG will not be displayed)
Replace the SYS board.
Step 1. Check the installation status of
CN132 on the SYS board and the
corresponding connector on the LGC
board.
Step 2. Replace the harness connected
to CN132
Step 3. Replace the LGC board.
Step 4. Replace the SYS board.
Step 1. Check the installation status of
CN131 and CN132 on the SYS board
and the corresponding connector on the
LGC board.
Step 2. Replace the harness connected
to CN131 and CN132 in sequence
Step 3. Replace the LGC board.
Step 4. Replace the SYS board.
Step 1. Update scanner firmware.
Step 2. Replace the SYS board.
Replace the SYS board.
Refer to C260 Troubleshoot of service
manual and check each item.
Refer to C261 Troubleshoot of service
manual and check each item.
Refer to C262 Troubleshoot of service
manual and check each item.
Refer to C270 Troubleshoot of service
manual and check each item.